User guide
Table Of Contents
- Presentation
- Warning
- Copyright
- 1 References
- 2 Packaging
- 3 General presentation
- 4 Characteristics and Services
- 5 Use of the modem
- 5.1 Starting with the modem
- 5.2 Specific recommendations for the use of the modem in vehicles
- 5.3 GSM led of the modem
- 5.4 Echo function of AT commands deactivated
- 5.5 Checking the quality of the GSM reception signal
- 5.6 Verification of PIN code
- 5.7 Verification of modem registration on GSM network
- 5.8 Verification of modem registration on GPRS network
- 5.9 Verification of internal voltages of the modem
- 5.10 Main AT commands (HAYES)
- 5.11 Turning OFF the modem
- 5.12 Updating procedure of the modem
- 6 Trouble Shooting
- 7 Functional description
- 8 Technical characteristics
- 8.1 Mechanical characteristics
- 8.2 Electrical characteristics
- 8.3 Environmental characteristics
- 8.4 Standards/Conformities
- 9 Security recommendations
- 10 Recommended accessories
- 11 Client support
EG_GenPro25e_1055_UG_000_UK Page 17 / 66
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO & GENER reserves the right to make any modification.
Dct_427_01
Female Micro FIT Connector with 2 male pins:
This connector of the GenPro 25e is used for the GPIO (2 Inputs signals).
Figure 6 : 2-pin Micro FIT connector
Table 2 : 2-pin Micro FIT connector
Pin N°
Standard
name
Circuit I/O Option I/O Option I/O
1 INPUT 2
Opto
5 / 35 V
I
Analog Input ANA-
1 0-10V
I
Analog Input ANA-1
4-20mA
I
2 INPUT 3
Opto
5 / 35 V
I
One Wire INPUT
multi-slaves 0-3V
I/O I/O