User guide
Table Of Contents
- Presentation
- Warning
- Copyright
- 1 References
- 2 Packaging
- 3 General presentation
- 4 Characteristics and Services
- 5 Use of the modem
- 5.1 Starting with the modem
- 5.2 Specific recommendations for the use of the modem in vehicles
- 5.3 GSM led of the modem
- 5.4 Echo function of AT commands deactivated
- 5.5 Checking the quality of the GSM reception signal
- 5.6 Verification of PIN code
- 5.7 Verification of modem registration on GSM network
- 5.8 Verification of modem registration on GPRS network
- 5.9 Verification of internal voltages of the modem
- 5.10 Main AT commands (HAYES)
- 5.11 Turning OFF the modem
- 5.12 Updating procedure of the modem
- 6 Trouble Shooting
- 7 Functional description
- 8 Technical characteristics
- 8.1 Mechanical characteristics
- 8.2 Electrical characteristics
- 8.3 Environmental characteristics
- 8.4 Standards/Conformities
- 9 Security recommendations
- 10 Recommended accessories
- 11 Client support
EG_GenPro25e_1055_UG_000_UK Page 23 / 66
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO & GENER reserves the right to make any modification.
Dct_427_01
5.1.2 Installation of the modem
To install the modem, it is recommended to do the following operations with the modem turned OFF:
- Remove the SIM card cover on the back side.
- Carefully insert the SIM card in the reader.
Figure 14 : Insertion SIM card
Way of insertion
of SIM card
- Push the SIM card until hearing a "clic" that ensures its correct positioning.
- Put the SIM cover back.
- Connect the GSM antenna to the SMA-F connector.
- For the connection to the DTE, connect the V24 link via the 15-pin Sub HD cable.
- Connect the supply cable to the continuous and regulated power source (for an automobile
application, see paragraph 5.2 Specific recommendations for the use of the modem in vehicles).
- Connect the supply cable to the modem and turn ON the external power supply.
The modem is now ready.
Depending on the application installed inside the equipment:
- Without library: corresponds to the Bootloader.
- With the ERCO & GENER transparent mode application
- The ERCO & GENER application EasePro-V2.xx
- The owner application.
We obtain different display. See following paragraph.