User guide
Table Of Contents
- Presentation
- Warning
- Copyright
- 1 References
- 2 Packaging
- 3 General presentation
- 4 Characteristics and Services
- 5 Use of the modem
- 5.1 Starting with the modem
- 5.2 Specific recommendations for the use of the modem in vehicles
- 5.3 GSM led of the modem
- 5.4 Echo function of AT commands deactivated
- 5.5 Checking the quality of the GSM reception signal
- 5.6 Verification of PIN code
- 5.7 Verification of modem registration on GSM network
- 5.8 Verification of modem registration on GPRS network
- 5.9 Verification of internal voltages of the modem
- 5.10 Main AT commands (HAYES)
- 5.11 Turning OFF the modem
- 5.12 Updating procedure of the modem
- 6 Trouble Shooting
- 7 Functional description
- 8 Technical characteristics
- 8.1 Mechanical characteristics
- 8.2 Electrical characteristics
- 8.3 Environmental characteristics
- 8.4 Standards/Conformities
- 9 Security recommendations
- 10 Recommended accessories
- 11 Client support
EG_GenPro25e_1055_UG_000_UK Page 47 / 66
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO & GENER reserves the right to make any modification.
Dct_427_01
7.6.2 RESET sequence
To activate the emergency RESET sequence, the RESET signal must be put downwards during at least 10
ms.
As soon as the modem has been RESET, if a SIM card is inserted inside the SIM reader, you must wait for
the end of the initialization before accessing it again.
Figure 20 : RESET sequence
Using the RESET does not restore the factory parameters.
7.7 WatchDog
The Hardware WatchDog function allows the surveillance of the modem software activity: the Software
management of the WatchDog is implanted in the embedded application by default. In the case of a
development (EGM) it must be implanted in the embedded application of the final customer.
If the software activity is interrupted, the WatchDog component starts a hardware Reset.
The WatchDog function is active only if the SIM card is present.