User guide
Table Of Contents
- Presentation
- Warning
- Copyright
- 1 References
- 2 Packaging
- 3 General presentation
- 4 Characteristics and Services
- 5 Use of the modem
- 5.1 Starting with the modem
- 5.2 Specific recommendations for the use of the modem in vehicles
- 5.3 GSM led of the modem
- 5.4 Echo function of AT commands deactivated
- 5.5 Checking the quality of the GSM reception signal
- 5.6 Verification of PIN code
- 5.7 Verification of modem registration on GSM network
- 5.8 Verification of modem registration on GPRS network
- 5.9 Verification of internal voltages of the modem
- 5.10 Main AT commands (HAYES)
- 5.11 Turning OFF the modem
- 5.12 Updating procedure of the modem
- 6 Trouble Shooting
- 7 Functional description
- 8 Technical characteristics
- 8.1 Mechanical characteristics
- 8.2 Electrical characteristics
- 8.3 Environmental characteristics
- 8.4 Standards/Conformities
- 9 Security recommendations
- 10 Recommended accessories
- 11 Client support
EG_GenPro25e_1055_UG_000_UK Page 9 / 66
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCO & GENER reserves the right to make any modification.
Dct_427_01
Warning
• ERCO & GENER to read carefully all documents linked to the GenPro 25e (User Guide, Application
Notes, Command List).
• ERCO & GENER cannot be held responsible for:
- Problems due to an inappropriate use of the GenPro 25e.
- Problems due to a wrong configuration
- Problems due to the wrong use of an embedded software application developed or supplied by a
third party.
- Dysfunctions due to the absence or a bad coverage of the GSM, GPRS networks.
- Dysfunctions if the product is used for the watching of physical persons where human life is
engaged.
• ERCO & GENER reserves the right to modify the functions of its products "GenPro 25e" and
"EasePro" without previous notice.
- In order to avoid any risk of electrocution, do not open the casing.
- For any functioning, the casing must be closed.
- No internal part can be repaired by the user. The GenPro 25e must be returned to the factory for any
repair.
- The GenPro 25e must be placed in a normally ventilated area, out of sources of heat.
- In order to guarantee the electromagnetic compatibility, the length of the serial cable, the power cable and
the inputs/outputs cable must not exceed 3 meters.
- The GenPro 25e must not be connected directly to the mains supply; a voltage adapter must be used.
SCRAP THE WORN BATTERIES ACCORDING TO THE USUAL INSTRUCTIONS