User Manual

3A-2
3A-3
3A-4
Position the arm assembly/wall plate [03] at
your desired height and line up the holes with
your stud center line. Level the arm
assembly/wall plate [03]
and mark the holes.
Drill 2 pilot holes using a 5/32 in.(4 mm)
diameter drill bit. Make sure the depth is
not less than 2 23/64 in.(60mm).
25/64 in.(10 mm)
Socket Wrench
03
ø5/32 in.(4mm)
2 23/64 in.(60mm)
Install the arm assembly/wall plate [03] using
lag screws [A1] . Tighten the lag screws [A1]
only until the they are pulled firmly against the
arm assembly/wall plate [03].
03
UP
UP
WARNING:
●Avoid potential personal injury or property damage! DO NOT over-tighten the lag screws
[A1]. Tighten the lag screws [A1] only until they are pulled firmly against the wall plate.
●Ensure the wall plate is securely fastened to the wall before
continuing to the next step.
● Any material covering the wall must not exceed 5/8 in. (16 mm)
● Mount
the wall plate directly onto the concrete surface
● Minimum solid concrete thickness: 203 mm (8 in.)
● Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.)
● Never drill into the mortar between blocks
Wall
Anchor
A2
Step 3B Solid Concrete or Concrete Block Option
08