For All Size Pets For All Size Pets OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS Congratulations for purchasing the “AUTOPETOASIS”. Your pet will now be able to drink fresh, clean and aerated water all the time. Before you can use this appliance you need to follow some simple steps to assemble the Autopetoasis. CHECK LIST Please open the package and check to see if the following components are in the package. Also check for any apparent damage to the parts in the package. Please call 1-630-390-1286 or email to contact@ergosys.net if you need any assistance.
5. Insert the flow tube into the opening in the body and push/snap into place. Insert the bottle stand, position and push into place. 6. Clean bottle prior to use. Unscrew the valve from the bottom of the water bottle and fill the container with water. Using the bottom handle fill the container with potable (drinking) water. 7. Screw the valve back to the bottom of the bottle. 8. Turn the bottle over and hold the bottle with the top handle. Place the bottle in the center of the body. 9.
FILTER REPLACEMENT 1. 2. 3. 4. 5. Remove the water bottle from the Autopetoasis body. Unscrew the filter from its retaining cap. (Counterclockwise direction) Rinse new filter in running water and install new filter on to cap. (Clockwise direction) Fill water bottle with water. Place water bottle within the Autopetoasis. Note: If you do not rinse filter prior to installation, loose carbon particles will be discharged from the filter into the Autopetoasis. These particles are loose due to transportation.
