Auto Pet Oasis Manual

OPERATING INSTRUCTIONS
CHECK LIST
ASSEMBLY
Congratulations for purchasing the “AUTOPETOASIS”. Your pet will now be able to
drink fresh, clean and aerated water all the time. Before you can use this appliance you need
to follow some simple steps to assemble the Autopetoasis.
Please open the package and check
to see if the following components
are in the package. Also check for
any apparent damage to the parts in
the package.
Please call
1-630-390-1286 or email
to
[e-mail] if you need
any assistance.
COMPONENTS
1. Pet Oasis body.
2. Transformer for pump.
3. Pet Oasis bowl.
4. Water storage bottle.
5. Oval O-rings pre installed
(quantity 2).
6. Spare o-ring/gaskets (located
under the bowl).
7. Plastic nuts (quantity 2).
8. Filter body.
9. Filter.
10. Filter cover.
11. Valve.
12. Flow tube.
13. Pump.
14. Bottle stand.
1. Pet Oasis body, filter body, filter and pump will
be pre-assembled.
2. Remove the bottle and bottle stand from the
body assembly.
3. Insert the bowl through the front of the body.
Make sure the oval water inlet tube aligns with
the oval hole in the body. Hand tighten the bowl
using the two plastic nuts.
4. Pre-wash the new filter in running tap water and
install inside the filter container. Make sure that
you hand tighten the filter to the cap. Do not use
any tools.