User's Manual

3-3

LANDING GEAR ASSEMBLY INSTALLATION

3-4

.32-.36 CO0LING FAN/HUB INSTALLATION

3mm Lock Nut

........4 pc

3x12mm Socket Head Bolt

........4 pc

3mm Flat Washer

........4 pc

4x4mm Set Screw

........4 pc

Note: If you are building the Ergo .46 3D Version,

proceed to Step 3-4.1

O.S. .32SX-H Installation

For proper installation of this engine, it will be

necessary to purchase the O.S. Prop Drive

Washer for this engine (Part #23408000).

*It is recommended that a Piston Locking Tool

be used to properly secure the Fan Assembly to

the engine.

3x5mm Socket Head Bolt

........4 pc

3x12mm Socket Head Bolt (4 pc)

3mm Flat Washer (4 pc)

Landing Strut

Landing Gear Dampers (4 pc)

Landing Skid Cap

Landing Skid

20mm

Antenna Tube

4x4mm Set Screw (4 pc)

3mm Lock

Nut (4 pc)

Cooling Fan Hub .32-.36

Cooling Fan .32-.36

Nut Supplied with Engine

3x5mm Socket

Head Bolt (4 pc)

Use Threadlock

For proper installation of the fan assembly, it is neccessary for

the engine to have the prop drive washer installed.

Prop drive washer must be

used for correct installation

* Revolution 1003 Piston Locking Tool

(Purchased Separately)