Installation instructions

OCT-08 www.ergotechgroup.com
ERGOTECHGROUP,INC.
8WestchesterPlaza
Elmsford,NY10523
91434
7
3800
To adjust monitors:
To slide along extrusion:
Lift the monitor from the
bottom until it slides freely along the extrusion
groove and then slowly release your support until it
drops back into its secured position. The monitor will
not slide easily until weight is removed from the
quick release clip by lifting the bottom slightly as
describe above.
Left/Right and Up/Down
: Grasp monitor with both
hands and adjust to desired position.
Special Interest
Articles:
• Add a highlight
or your point of
interest here.
• Add a highlight
or your point of
interest here.
• Add a highlight
or your point of
interest here.
Installation Instructions
Product # 100-D16-B03
–
Tri
p
le Desk Stand
1. Remove the base from the box and place it on a flat
surface.
2. Insert the pole into the cone by threading the pole
onto the PEM stud on the base and then tightening
the set screw with the 3mm Allen key provided. Be
certain the pole is fully seated and tightened into the
cone and the set screw is securely tightened.
3. Place the arm assembly over the pole with the
grooves in the extrusions facing up.
4. Tighten the T-handle on the back side of the pole
clamp to hold the arm assembly securely on the pole.
5. Attach quick release pivots to back of each monitor
with screws provided. Be sure that silver release
button is toward the top of the monitor.
6. Starting with the center monitor (standard pivot),
place it onto the middle extrusion by tipping it back
approximately 45 degrees and then down until the
silver button engages the groove and clicks down into
place. Repeat this process with the two lateral
monitors (micro-height adjustable pivots).
To tension the vertical adjustment to the weight of monitor: Tighten the 5mm bolt on the right side of the pivot
with the Allen key provided.
To tile the monitors horizontally:
Turn the handle on the top of the micro-height adjustable pivots until the three
monitors are properly aligned.
To remove the monitors from the extrusions
: Take the weight from the monitor with one hand on the bottom and
tip it back slightly while using the other hand to lift the top of the silver release button. Lift up and back and this
will release the monitor from the stand.
Cone