User guide

ManualsBrandsErgotron ManualsOffice Furniture97-715

888-97-282-G-00 rev. C • 12/12

1/13

StyleView® Primary Drawer

12.5"

(315 mm)

10.5"

(267 mm)

10.5"

(267 mm)

3.75"

(96 mm)

2.5"

(64 mm)

<0.25 lbs (0.1 kg)< 2 lbs (1 kg)

User's Guide - English

Guía del usuario - Español

Manuel de l’utilisateur - Français

Gebruikersgids - Nederlands

Benutzerhandbuch - Deutsch

Guida per l’utente - Italiano

Användarhandbok - svenska

ユーザーガイド : 日本語

用户指南 : 汉语

www.ergotron.com

User Guide

Total weight capacity per drawer. Total weight capacity per drawer.

Summary of content (13 pages)

PAGE 1
User Guide StyleView® Primary Drawer www.ergotron.com User's Guide - English Guía del usuario - Español Manuel de l’utilisateur - Français Gebruikersgids - Nederlands Benutzerhandbuch - Deutsch Guida per l’utente - Italiano Användarhandbok - svenska ユーザーガイド : 日本語用户指南 : 汉语 or < 2 lbs (1 kg) Total weight capacity per drawer. 2.5" (64 mm) <0.25 lbs (0.1 kg) Total weight capacity per drawer. 10.5" 10.5" (267 mm) (267 mm) 12.5" (315 mm) 3.75" (96 mm) 888-97-282-G-00 rev.
PAGE 2
WARNING 14mm (9/16”) IMPACT HAZARD! MOVING PARTS CAN CRUSH AND CUT. Minimize Lift Tension BEFORE: · Removing Mounted Equipment. · Shipping Cart · Storing Cart CAUTION: Close worksurface before opening drawers. Open only one drawer at a time. Do Not push cart when drawers or worksurface are open. Failure to follow these instructions may cause the cart to be unstable. To Minimize Lift Tension 1. Lower worksurface to lowest position. 2.
PAGE 3
1 Remove the top cover. 2a 2x b Hang the drawer tabs onto the brackets on the cart. M6 x 43mm c 2x M6 x 10mm 3 Open worksurface. Laptop Carts LCD Carts 888-97-282-G-00 rev.
PAGE 4
Route the USB cable from the drawer controller to the USB hub located inside the cart storage area. Powered Carts Non-Powered Carts 5 Attach drawer keypad. Laptop Carts LCD Carts or 1x 2x M4 x 14mm 1x 1x 4x M3 x 14mm 888-97-282-G-00 rev.
PAGE 5
6 Route the keypad cable through the bottom of the storage area to the drawer controller. Laptop Carts 7 or LCD Carts Plug the keypad's cable into the drawer controller. Powered Carts Non-Powered Carts 888-97-282-G-00 rev.
PAGE 6
LiFe Powered Carts 8 a Route drawer power cable into base for Powered Carts Only Turn off all mounted equipment. d SLA Powered Carts / Non-Powered Carts b Remove rear base cover. e REAR VIEW f i FRONT VIEW Turn power system off by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut off. Remove front base cover. FRONT VIEW g Remove cable management cover and route drawer power cable down into base and connect to power system. Replace front base cover.
PAGE 7
SLA Powered Carts 8 a d e g h Non-Powered Carts Route drawer power cable into base for Powered Carts Only Turn off all mounted equipment. b Disconnect Power System from power source. c Turn power system off by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut off. Remove front base cover. Remove rear base cover and cable management cover. f Route drawer power cable down into base and connect to power system. Replace cable management cover and rear base cover.
PAGE 8
Non-Powered Carts 8 How To Attach Battery Pack for Non-Powered Carts Only a Make sure all 4 batteries are in the drawer battery pack, then peel off the adhesive backing. b Attach battery pack to the back of the storage area. c Route cable down through the bottom of the storage area and plug into the drawer controller. Non-Powered Carts 888-97-282-G-00 rev.
PAGE 9
Replace top cover on drawer. 10 Replace worksurface. Laptop Carts or LCD Carts 888-97-282-G-00 rev.
PAGE 10
11 Adjustment It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation. Adjustments should move smoothly and easily through the full range of motion and stay where you set it.
PAGE 11
Powered Carts Non-Powered Carts NOTE: User should change Master Personal Identification Number (PIN) upon receipt of cart. 12 1x Lost Master PIN Contact Ergotron Customer Care for instructions. Ensure that the main power system batteries are installed and functioning. The power does not need to be turned on at the power system user interface. CAUTION: Close worksurface before opening drawers. Open only one drawer at a time. Do Not push cart when drawers or worksurface are open.
PAGE 12
Non-Powered Carts 12 AutoLock Drawer Battery Pack CAUTION! Only use rechargeable batteries. Using nonrechargeable batteries may cause product damage. 4x AA Rechargeable Nickel Metal Hydride USB to computer. Before the Auto Lock Drawer will function, you will need to charge the ALD batteries for at least 1 or 2 hours. To charge ALD batteries computer needs to be powered on and connected to the USB hub. USB to charge ALD batteries. 1x CAUTION: Open only one drawer at a time.
PAGE 13
888-97-282-G-00 rev.