User guide

888-97-282-G-00 rev. C • 12/12
12/13
1
1
2
1
2
1
2
12
1x
4x
Non-Powered Carts
Unlock Drawer (3 methods):
• Enter Master PIN, then press desired drawer number*.
• Enter User PIN, then press desired drawer number*.
• Key - turn clockwise 1/4 turn
*Drawer Numbers:
Programming New PIN (Default Master PIN: 12345)
1
2
3
4
5
6
7
8
NOTE: User should
change Master PIN
upon receipt of cart.
Lock Drawer (2 methods):
• Wait 4 seconds for drawer to lock automatically
• Press 1 and 2 on number pad simultaneously
Lost Master PIN
Contact Ergotron Customer Care for instructions.
Drawer Troubleshooting
• Key pad numbers are dark
-Touch anywhere on number pad to activate back-light, (drawer remains
locked until you enter valid PIN)
-Check to make sure battery pack is connected.
• PIN is accepted but drawer does not open
-Make sure drawer is fully closed before entering PIN.
• Drawer won’t open when User PIN is entered
-Test system by entering Master PIN. If drawer doesn’t unlock, contact
Ergotron customer care for "Lost Master PIN" instructions.
AutoLock Drawer Battery Pack
Before the Auto Lock Drawer will function, you will need to charge the ALD batteries for at least
1 or 2 hours. To charge ALD batteries computer needs to be powered on and connected to the
USB hub.
USB to charge ALD
batteries.
USB to
computer.
Flashing LED: Meaning
1: Drawer is open
1 & 2: Waiting for drawer selection (see Unlock Drawer)
3 & 5: Unit is ready to program master or user PINs (see Programming New PIN)
5: Drawer is unlocked
All: New PIN accepted
AA
Rechargeable
Nickel Metal
Hydride
Enter Master PIN, then press 1.
Numbers 3 and 5 on the Keypad will start  ashing, indicating the Master PIN has been accepted.
Simultaneously press 3 and 5 while they are  ashing.
All the numbers will light (you have 3 seconds to enter a PIN).
Enter a new PIN—any sequence of 5 numbers. (The  rst PIN programmed is the new Master PIN.)
When the PIN is accepted, all of the LEDs will  ash once in acknowledgement (you have 3 seconds to enter the next PIN).
You can then proceed to program up to 11 PINs by repeating steps 5 and 6.
When  nished entering new PINs, system will exit program mode after 3 seconds with a series of LED  ashes.
Erase All Personal PINs (cannot erase only one PIN or Master
PIN):
1 Enter Master PIN, then press 1.
2 Press 3 and 5 simultaneously (while blinking).
3 Press 1 and 2 simultaneously.
CAUTION! Only use rechargeable batteries. Using non-
rechargeable batteries may cause product damage.
CAUTION: Open only one drawer at a time. Do Not push cart when drawers
are open. Failure to follow these instructions may cause the cart to be
unstable.