User guide

17/27
888-24-314-G-00 rev. B • 12/14
20
14mm (9/16")
b
a
M4 x 8mm
1x
ENGLISH
Adjustment
Release Brake to move riser.
Follow these instructions to tighten or loosen tension.
It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this
product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation.
Adjustments should move smoothly and easily through the full range of motion and stay where you set it. If adjustments are di cult and do not stay in the desired position, follow
the instructions to loosen or tighten the tension to create a smooth, easy adjustment motion. Depending on your product and the adjustment, it may take several turns to notice a
di erence.
Lift – Up and down
NOTE: Adjustment
may require 40 - 60
revolutions.
Loosen knob, tilt Display to desired
position then retighten knob.
Tilt – Forward and Backward