Manualshelf

User guide

ManualsBrandsErgotron ManualsOffice FurnitureStyleView
18192021222324252627
23/27
888-24-314-G-00 rev. B • 12/14
45
1
1
2
23
3
8
910
ab
6 7
ENGLISH
Cart Storage Instructions
Turn o all mounted equipment.
Turn o all mounted equipment.
Plug power cord into
appropriate wall outlet to
fully charge battery to 100%
(all indicator lights will be
illuminated). Power system
must be fully charged
before storing!
Once battery has been charged to 100%, turn power system o .
a. Turn power system o by holding down the AC Outlet Power button for 1 - 3 seconds. Power light will shut o .
b. Turn both circuit breakers to "OFF".
NOTICE:
Warranty on fully charged batteries left in an unused state for more than three (3) consecutive months is automatically void.
Warranty on fully discharged batteries left in an unused state for more than three (3) consecutive days is automatically void.
Turn power system o by holding
down the AC Outlet Power button for
1 - 3 seconds. Power light will shut o .
Turn both circuit breakers to "OFF".
Black
Red
Store battery in cool, dry area while Cart is out of use. Optimal
storage temperature is 15°C/59°F. Battery voltage should
be checked every three (3) months. If voltage drops below
12.5VDC, fully recharge battery. Contact Ergotron Customer
Care for information about how storage might impact the
battery warranty.
Short Term Storage -
If the Power System will be idle for up to 3 months, the battery should be fully charged before storage.
Long Term Storage -
If the Power System will be idle for 3 months or more, the battery should be removed from the cart and recharged during storage.
Short Term Storage -
If the Power System will be idle for up to 3 months, the battery should be fully charged before storage.
Long Term Storage -
If the Power System will be idle for 3 months or more, the battery should be removed from the cart and recharged during storage.
WARNING: Do not remove or replace the batteries while cart is located in an oxygen rich or hazardous environment. Sparking may occur.
Caution: Remove Black (-) before removing Red (+).
Disconnect Power System and Multiple Socket Outlet from
power source.