User guide

15/24
14
abc
7hrs
15
888-24-300-G-00 rev. B • 10/14
ENGLISH
Battery Charge/Discharge
Initial Power on/Charge Battery (takes aproximately 7 hours to charge)
Turn on power system by holding power
button down for 1 - 3 seconds.
With cart's power cord plugged into
the wall outlet, wait until cart is at
100% charge. (takes aproximately
up to 7 hours to charge)
Plug Cart's Power Cord into wall outlet.
Do Not stretch coiled cord further than 8 feet
(2.5 meters), damage to the cord may occur.
Battery has 100% charge.
Light  ashes when charging (power cord plugged into wall outlet)
Allow battery to continue
charging until light stops  ashing. After light stops  ashing, it is OK to unplug the
power cord from the wall. You can use cart while charging.
Battery has less than 90% charge.
Battery has less than 70% charge.
Battery has less than 50% charge.
Battery has less than 30% charge. Light is red and alarm beeps. Plug-in power cord and charge
to 100%! You can use cart while charging.
Alarm Mute button. Pressing this will temporarily mute alarm.
Power button for internal power system outlets. Pressing this will provide or remove power to/
from components plugged into the internal outlets.
When lit, alarm is enabled and
will beep when battery charge
gets below 30%. For details on
enabling and disabling alarm
contact Ergotron Customer Care.
When lit, the power system is on.
When dark, power system is o .
This power system interface will alert you to the percentage of charge remaining in the cart battery with a series of steady or  ashing
red, yellow or green lights, and an alarm that will beep when charge gets below 30%. Remember, the battery needs to be charged to
100% every day, and you can use the cart while charging, so plug-in cord as often as possible to avoid running out of power!
NOTE: Put monitor in power save mode to optimize battery run time.
NOTE: Frequent operation of the cart while battery charge levels are
below 30% will signi cantly reduce the life of your battery and may
void your battery warranty.
CAUTION: There is no on/o switch on
this equipment; the AC power cord is the only
power disconnect. The socket outlet should be
easily accessible and should be installed near the
equipment.
Keyboard Light
Keyboard Light will automatically turn
o after 15 minutes if not manually
turned o .