User guide

11/16
888-24-298-G-00 rev. A • 08/14
10
14mm (9/16")
b
a
9
M4 x 8mm
1x
ENGLISH
Adjustment
Release Brake to move riser.
Follow these instructions
to tighten or loosen
tension.
It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time
equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment
steps to ensure safe and optimum operation.
Adjustments should move smoothly and easily through the full range of motion and stay where you set it. If adjustments are di cult and do not
stay in the desired position, follow the instructions to loosen or tighten the tension to create a smooth, easy adjustment motion. Depending on
your product and the adjustment, it may take several turns to notice a di erence.
Lift – Up and down
NOTE: Adjustment may require
40 - 60 revolutions.
Loosen knob, tilt Display to desired
position then retighten knob.
Tilt – Forward and Backward
Set-up