User guide

14/16
888-24-298-G-00 rev. A • 08/14
1
1
5
5
6
2
2
3
4
4
3
12
1
1
2
3
1
2
1
2
1
2
ENGLISH
Ergonomics
Working
customize - to your size
1 Set top of monitor screen about one inch below eye level - Release brake and lift or lower riser
as needed.
2 Tilt screen for comfortable viewing and to reduce eye and neck strain.
3 Pull keyboard tray forward and position mouse tray on right or left, as needed.
4 Work with elbows bent at about 90° to minimize muscle strain.
5 If the riser moves up and down with di culty, or if it drifts out of set position, consult the product
manual for adjustment information.
6 Stay in charge!
Powered carts should be plugged into outlet as often as possible to keep battery charged and
computer running.
Moving
stow - before you go
1 During normal movement, release brake and lower worksurface to
lowest position for optimal stability and unobstructed view.
2 Tuck away open trays and return mouse, scanner and other accessories
to their places.
3 Unlock both front casters.
4 Push cart from rear with elbows bent at about 90° to maximize control
and minimize muscle strain.
5 Don’t run out!
Before moving, make sure cord is unplugged from outlet and hooked to
basket for safe travel. Remember, charge battery fully 100% every day!
Keyboard Light
1. Turn Computer on.
2. Test Keyboard Light.
Keyboard Light will automatically turn o after 15 minutes if not
manually turned o .
Set-up
Auto-Lock Drawer
Lock Drawer:
• Wait 4 seconds for lock to engage automatically.
NOTE: Always ensure drawer is pushed in all the way and engaged with lock.
Drawer Troubleshooting
• No LEDs on keypad when pressing any number:
•Verify battery box is connected to controller.
• Verify keypad cable is connected to controller.
• Verify battery box switch is in the ON position and that batteries are
properly installed.
• Drawer selection not available when User PIN is entered:
• Check to make sure drawer cable is installed securely.
• Remove power from drawer system for 10 seconds and re-apply.
• LEDs  ash red/green after User PIN in entered:
• Battery charge is low, check to make sure USB charging cable is
plugged into computer and computer is ON.
LEDs/Alarm Meaning:
1,2,3,4, or 5 LED ON green: Corresponding Drawer is open.
1,2,3,4, or 5 LED  ashing red and alarm sounding: Corresponding Drawer is open longer than 20
seconds. Mute alarm by pressing  ashing button corresponding to open drawer.
All available drawer numbers  ashing green: Waiting for drawer selection (see Unlock Drawer).
All LEDs  ashing green: Pharmacy mode, all drawers are unlocked.
All LEDs blink red twice: PIN entry rejected/exit current mode after 5 seconds timeout.
All LEDs blink green 3 times: PIN entry accepted.
All LEDs  ashing red: Firmware update in progress.
All LEDs  ashing red/green: System power ON or low battery condition.
Unlock Drawer (2 methods): NOTE: All Drawers in row must be closed before a new row can be unlocked.
• Enter User PIN (only numbers for available drawer rows  ash green), then press desired drawer row number*.
• Key - turn clockwise 1/4 turn
*Drawer Row Numbers: