StyleView®Scanner Shelf Max weight: 2 lbs (1 kg) SV Cart & Head Unit • Option 1 - LCD Carts • Option 2 - Laptop Carts 3 • Option 3 - Wall Track 6 • Option 4 - Back of SV Cart 7 Reduce Reuse Recycle 888-97-319-W-01 rev.
ENGLISH Hazard Symbols Review Symbol These symbols alert users of a safety condition that demands attention. All users should be able to recognize and understand the significance of the following Safety Hazards if encountered on the product or within the documentation.
Option 1 - Mounting to right or left side of LCD head unit 1 2 Open Worksurface with key. a. Attach the shelf bracket to the bottom of the head unit using two M4x16mm Phillips screws. b. Loosely attach the scanner shelf to the bracket using two M4x8mm Phillips screws. Adjust the shelf to the desired height; ensure that the shelf is level, then tighten the screws. c. Close and lock worksurface. d. Go to page 8 for options on how to secure scanner to shelf.
ENGLISH Option 2 - Mounting to right or left side of laptop head unit CAUTION: Do Not Exceed Maximum SV Laptop Cart Weight Capacity 22 lbs. (10 kg). This is the sum of laptop, keyboard/mouse, scanner and any worksurface load, including drawers, if present. Failure to heed this caution may result in personal Injury or property damage. 1 a. Unlock both sides of worksurface. b. Remove worksurface. a b 2 a.
Option 2 - Mounting to right or left side of laptop head unit (cont.) ENGLISH 3 a. Loosely attach the scanner shelf to the bracket using two M4x8mm Phillips screws. b. Adjust the shelf to the desired height; ensure that the shelf is level, then tighten the screws. Close and lock worksurface. c Go to page 8 for options on how to secure scanner to shelf. d. After the scanner has been secured to shelf, follow Step 4 Adjustment, below.
ENGLISH Option 3 - Mounting to wall track 1 a. Attach the scanner shelf to the walltrack bracket using two 8/32x5/16” Phillips screws. Adjust the shelf to the desired height; ensure that the shelf is level, then tighten the screws. b. Go to page 8 for options on how to secure scanner to shelf. Note: several pair of mounting holes are available. a 2x 8/32x5/16” b 8 888-97-319-W-01 rev.
Option 4 - Mounting to rear of cart ENGLISH 1 a. Remove cap. b. If present, remove existing accessory by sliding it up off the slot in the riser. NOTE: loosen screws only, do not remove them. c. Attach t-nut to scanner shelf with M5x12 screws as illustrated. d. Slide shelf/nut assembly into slot, adjust shelf to the desired height and tighten the screws. a c b 2x d M5 x 12mm e 888-97-319-W-01 rev.
ENGLISH 3 Mounting Options a a b b c d 888-97-319-W-01 rev.
