Instruction manual

2 of 12
888-24-205-G-01 rev. C • 09/12
These symbols alert users of a safety condition that
demands attention. All users should be able to
recognize and understand the signi cance of the fol-
lowing Safety Hazards if encountered on the product
or within the documentation. Children who are not
able to recognize and respond appropriately to Safety
Alerts should not use this product without adult
supervision!
Hazard Symbols Review
Symbol Signal Word Level of Hazard
NOTE
A NOTE indicates important information that helps you
make better use of your Cart.
CAUTION
A CAUTION indicates either potential damage to
hardware or loss of data and tells you how to avoid the
problem.
WARNING
A WARNING indicates either potential for property dam-
age, personal injury, or death.
ELECTRICAL
An Electrical indicates an impending electrical hazard
which, if not avoided, may result in personal injury,  re
and/or death.
Safety
WARNING! TIPPING HAZARD!
When mounting accessories to the
WorkFit-D, they must stay within the foot
print. Do not mount accessories past the
front and rear worksurface! Failure to fol-
low this warning may result in equipment
damage and or personal injury.
826-463-00
WARNING
Moving Parts Can Crush And Cut
IMPACT HAZARD
1. Release hand brake and raise
worksurface to highest position.
2. Turn adjustment nuts at back of legs
counterclockwise until they stop (May
require 40-60 revolutions per leg).
To Minimize Lift Tension
Failure to heed this warning may
result in serious personal injury or
property damage!
For More information and instructions
visit www.ergotron.com or contact
Ergotron Customer Care at
1-800-888-8458.
- Removing Mounted Equipment
- Shipping Desk or Storing Desk
Minimize Lift Tension BEFORE:
✓
IMPORTANT! This product will need tension adjustments once installation is complete. Make sure all equipment
is properly installed on the product before attempting range of motion or tension adjustments. Any time
equipment is added or changed on this product resulting in a di erent mounted weight, you should repeat
the adjustment steps to ensure safe and optimum operation. This product should move smoothly and easily
through the full range of motion and stay where you set it. If movement is di cult or the product does not stay
where you set it, follow the adjustment instructions to loosen or tighten the tension to create a smooth, easy
motion. Depending on your product and the adjustment, it may take many turns to notice a di erence.
WARNING! After you complete your installation, never tip the desk to move or reposition
unless desk is raised to its highest position. Failure to follow these instructions may cause
lift engine to expand rapidly and may result in equipment damage and or personal injury.