User Manual

ManualsBrandsErica Synths ManualsEquipmentFusion 6VAC PSU

Make sure your Erica Fusion 6VAC PSU is conﬁgured for

power supply voltage in your country!

It is advised that installation is performed by

person, who has experience working with

220/110V voltages. Before installing the PSU,

make sure your modular system is turned oﬀ and discon-

nected from wall power socket.

Follow simple instructions below, and you will not go

wrong with the installation!

ERICA FUSION 6V AC PSU INSTALLATIONERICA FUSION 6V AC PSU

THANK YOU FOR ORDERING

ERICA FUSION MODULE!

The Erica Synths Fusion series modules are designed combin-

ing vacuum tubes and semiconductors therefore they bring

warm, powerful sound and crazy overdrive possibilities of

vacuum tubes into your modular system. Erica Fusion series

consist of whole range of modules used in sound generation

and shaping circuit – pure sine VCO with unique tube wavesh-

aper, VCO signal Mixer, Ringmodulator, VCF, VCA and Analogue

Delay/Chorus. Erica Fusion modules have insigniﬁcant (max

15mA) power consumption from eurorack power supply unit

(PSU), but they require separate, easy to install 6VAC PSU for

tube heaters. Erica Fusion 6VAC PSU is designed to power up to

7 Erica Fusion modules and is available from Erica Synths

SHOP or comes for free with purchase of 2 or more Erica Fusion

modules.

Summary of content (4 pages)

PAGE 1
ERICA FUSION 6V AC PSU THANK YOU FOR ORDERING ERICA FUSION MODULE! The Erica Synths Fusion series modules are designed combining vacuum tubes and semiconductors therefore they bring warm, powerful sound and crazy overdrive possibilities of vacuum tubes into your modular system. Erica Fusion series consist of whole range of modules used in sound generation and shaping circuit – pure sine VCO with unique tube waveshaper, VCO signal Mixer, Ringmodulator, VCF, VCA and Analogue Delay/Chorus.
PAGE 2
ERICA FUSION 6V AC PSU INSTALLATION Use spacers and screws supplied with the Erica Fusion PSU kit to ﬁx it in your modular case next to the eurorack power supply unit! Disconnect 220/110V wires from eurorack PSU! Connect 220/110V wires to relevant lugs of Erica Fusion PSU!
PAGE 3
ERICA FUSION 6V AC PSU INSTALLATION Use wires supplied with the Erica Fusion PSU kit to connect eurorack PSU back! One side of Erica Fusion PSU 6VAC output has to be connected to the GND of your modular system. Use the wire supplied with the kit to do so. Since 6VAC circuit is isolated, nothing wrong or critical will happen, if you connect this wire somewhere incorrectly. But that may aﬀect quality of sound of Erica Fusion modules.
PAGE 4
SAFETY INSTRUCTIONS PLEASE FOLLOW THE INSTRUCTIONS FOR USE OF THE ERICA FUSION VCF BELOW, ‘CAUSE ONLY THIS WILL GUARANTEE PROPER OPERATION OF THE MODULE AND ENSURE WARRANTY FROM ERICA SYNTHS. When installing and connecting the module, make sure your modular system is turned oﬀ and disconnected from wall power socket. Mind the polarity of eurorack PSU power cable! Follow signs on the PCB! 6VAC cable doesn’t have polarity and you can’t go wrong with connecting it.