Owner's manual
Fitting with pre-set
anchor in concrete
nut & washer
When installing on purlin, 16 gauge(0.0598")
[1.52mm] up to 12 gauge(0.1094")[2.78mm],
drill a 0.406"[10.3mm] hole in purlin and add
a 3/8" washer and 3/8"-16 nut to assembly.
CSBBRS1EG may be used on 12 gauge purlin.
Install a beam clamp by
following the installation
instructions for the beam
clamp being used.
1. Orient part in direction needed for installation.
2. Install using a 5/16"[8mm] hex head socket or wrench
to a minimum of 70 in/lbs[7.9Nm].
Branch Line Restraints are intended to be installed in accordance with NFPA®-13 and manufacturer's
installation instructions.
ERICO Beam Clamps
3000037EG
3000037PL
NA Part
Number
EU Article
Number
Rod Size
UL® Load Rating
FM® Load Rating
Orientation
45°-59° 60°-74° 75°-90°
CSBBRS3EG
---
3/8", 1/2"
425lbs (1891N) 310lbs (1380N)
190lbs (845N) 210lbs (935N)
n/a
CSBBRS3MEG
402241
M10, M12
CSBBRS3EG
W/3000037 (XX)
---
3/8", 1/2"
425lbs (1891N)
170lbs (755N) 210lbs (935N)
230lbs (1025N)
Lateral
CSBBRS3MEG
W/3000037 (XX)
402241
W/386820
M10, M12
200lbs (890N)
230lbs (1025N) 260lbs (1155N)
Longitude
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
CFS451_D
INSTRUCTION SHEET
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
1 OF 2
© 2011, 2012 ERICO International Corporation
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
completely
followed to ensure proper and safe installation and performance.
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
6.
other purpose.
FM is a registered certification mark of FM Approvals LLC, LTD
NFPA is a registered trademark of National Fire Protection Association, Inc.
UL is a registered trademark of UL LLC.