User's Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Preconditions
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Grounding RRU-N
- 3.2.5 Connecting the 48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation External Hybrid Combining Unit (EHCU)
- 6 Performing Concluding Routines
- 7 Verifying the Installation
- tables
Installation RRU-N
4.
Place the lower mounting fixture
on the pole, 500 mm below the
upper mounting fixture.
Note: The washers and nuts
for the studs indicated in the
figure must be saved for later
use (step 8).
B000087A
5.
Fasten the washers and nuts
until fingertight to the clamp
bolts.
B000088A
6.
Hoist the RRU-N up to its position
on the mast or pole.
Attach a rope to the eyes of the
RRU-N for lifting it up. Attach
another rope to the hole in the
lower part of the rear cover, and
pull it while hoisting the RRU-N
to avoid dangling.
750/1531-LZA 701 0001 Uen PA4 2008-07-31