User's Manual
Table Of Contents
- toc
- 1 Introduction
- 2 Tools and Documentation
- 3 Installation RRU-N
- Introduction
- Target Group
- 3.1 Preconditions
- 3.2 Installation Procedure
- Figure 1 Workflow for Installing the RRU-N
- 3.2.1 Unpacking and Checking the Material
- 3.2.2 Installing RRU-N on a Pole or a Mast
- 3.2.3 Installing RRU-N on a Wall
- 3.2.4 Grounding RRU-N
- 3.2.5 Connecting the 48 V DC Power
- 3.2.6 Connecting Optical Fiber Cable and Setting RRU-N Configura
- 3.2.7 Connecting Antenna Cables
- 3.2.8 Installing the Front Sunshield
- 4 Optional Installation External Splitter/Highway Function
- 5 Optional Installation External Hybrid Combining Unit (EHCU)
- 6 Performing Concluding Routines
- 7 Verifying the Installation
- tables
RBS Installation Instructions
2.
Drill the mounting holes in the
wall, and insert a plug into each
hole.
Use the depth restrictor, fitted to
the hammer drill, to regulate the
depth of each hole.
Note: An industrial vacuum
cleaner should be used for
removing dust and debris
created during drilling.
3.
Position the upper and lower
bracket over the drilled holes
and insert the bolts or nuts.
Use a spirit level to adjust
the horizontal position, and
tighten them according to the
recommendation given by the
site engineering.
Note: Use a sufficient number
of bolts to support the brackets.
The number of bolts depends
upon the wall material, as is
specified by site engineering
department.
K000184A
4.
Hook the RRU-N onto the stud
bolts on the wall brackets.
K000368B
12 50/1531-LZA 701 0001 Uen PA4 2008-07-31