User's Manual

ManualsBrandsEricsson-LG ManualsElectronicsDECT fixed base part of ket telephone system

ipLDK-60 Hardware Description and Installation Manual Issue 2

July, 2010

This material is copyrighted by LG-Ericsson Co., Ltd. Any unauthorized reproductions, use or disclosure of this material, or any part thereof, is

strictly prohibited and is a violation of Copyright Laws. LG-Ericsson reserves the right to make changes in specifications at any time without notice.

The information furnished by LG-Ericsson in this material is believed to be accurate and reliable, but is not warranted to be true in all cases.

ipLDK-60 are trademarks of LG-Ericsson Co., Ltd.

All other brand and product names are trademarks or registered trademarks of their respective companies.

Regulatory Information

Before connecting the ipLDK-60 to the telephone network, you may be required to notify your local serving

telephone company of your intention to use "customer provided equipment". You may further be required to

provide any or all of the following information:

PSTN line Telephone numbers to be connected to the system

Model name ipLDK-60

Local regulatory agency registration number locally provided

Ringer equivalence 0.5B

Registered jack RJ11C & RJ45

The required regulatory agency registration number is available from your local representative of LG-Ericsson.

This equipment complies with the following regulatory standards, that is, the safety requirements of EN60950-1,

UL 60950-1/CSA C22.2 No. 60950-1-03 and the EMC requirement of EN55022 and EN55024.

If the telephone company determines that customer provided equipment is faulty and may possibly cause harm or

interruption in service to the telephone network, it should be disconnected until repair can be affected. If this is not

done, the telephone company may temporarily disconnect service.

The local telephone company may make changes in its communications facilities or procedures. If these changes

could reasonably be expected to affect the use of the ipLDK-60 or compatibility with the network, the telephone

company is required to give advanced written notice to the user, allowing the user to take appropriate steps to

maintain telephone service.

The ipLDK-60 complies with rules regarding radiation and radio frequency emission as defined by local regulatory

agencies. In accordance with these agencies, you may be required to provide information such as the following to

the end user.

FCC Interference Statement

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment

under FCC rules.