User's Manual

LIP-8040L User Guide Issue 1
14 August, 2008
NOTE—When the BTU is used for a call, the Speaker
button LED will illuminate and the speaker mode
cannot be used. If the phone handset is taken off-
hook while in BT mode, the voice path will directly
be connected to the handset; press the Speaker
button to activate the BTU headset.
To unpair the BTU headset:
• Set the Bluetooth headset to pairing mode,
• Press the
TRANS/PGM button,
• Dial *8,
• Dial 2 (disable),
• Press the OK
soft button.
To check BTU paired information:
• Press the
TRANS/PGM button,
• Dial *8,
• Dial 3,
• Press the OK
soft button.
To use the BTU headset:
• Press the
SPEAKER button,
OR
• Press the Call Start button on the BTU headset,
• Place call as you normally would.
To answer a call with the BTU headset:
• When an incoming call is received, ringing will be
present at the Station and the BT headset,
• Press the BT Call Start button, or press the Speaker
button,
OR
• Lift the handset.
2.5 Using a Serial DSS
The LIP-8012DSS, LIP-8012LSS, and LIP-8048DSS
can be connected with the LIP-8040L using the RS-232
cable. Be sure to verify the serial DSS and LSS
capacities with the iPECS System to ensure usability
(refer to iPECS Manual). The following graphics show
the front and rear view of each.
NOTE—A Linked Pair slave station cannot use a
serial DSS.