User's Manual
Table Of Contents
- Introduction
- LCD, Speakerphone & Related Features
- Receiving calls
- Placing a call
- Transfer, Conference & Other Call Handling
- Send & Retrieve Messages
- Remote System Access
- Misc. Features
- PBX, Centrex & ISDN features
- Features & Flex buttons
LIP-8040L User Guide Issue 1
26 August, 2008
busy station returns to an idle state, the system will call
your Station; after you answer the callback, the system
t
station by dialing the last digit of the Intercom number.
4.1.2
(PGM111-FLEX10), the
ring/message LED will flash.
4.2 Extern
4.2.1
will call the previously busy station.
If you are the Attendant or Secretary, you may activate
Intrusion. You may also use Step Call; dial the nex
To busy station:
To r a busy station:
Camp-On (wait off-hook) for a
• Press * and await an answer.
request a Callback (wait on-hook) fo
• Press the
MSG button and hang-up.
To make a Voice Over announcement to a busy station:
• After the Splash tone is heard, begin speaking.
• Dial #,
Leaving a Message Wait
If the called user does not answer or is in DND mode,
you may leave a Message Wait. The called user will
receive a Message Wait indication; the message icon
will be displayed. If the ring/message LED is set to
Message Wait Indication
To
• r in DND mode,
press the
MSG button and hang-up.
activate Message Waiting:
When calling a number that is busy o
al Calls
Placing external CO/VoIP calls
External calls are placed on CO/IP lines. These ‘lines’
are accessed either using a button on the iPECS Phone
assigned as a CO/IP line or using dial codes. The
CO/IP lines are grouped for different types of calls, local,
long distance, etc. Using the CO/IP line group code,
you will be able to access any line from the group. A
Flex button on the iPECS Phone assigned as a
LOOP
button lets you access a line from a group. Dial codes
for access to CO/IP lines are: