User's Manual Part 1

LIP-8012D & LIP-8024D User Guide Issue 1
25 August, 2008
4. PLACING A CALL
ver
ice
will be heard. Ring or
normally determined by settings at
t you may change this by dialing ‘#’
after placing the call. By changing the mode, a Voice
low
You can assign a Flex button for Direct Station
. The
DSS/BLF
4.1 Internal Calls
You can place calls to other stations in the system o
the Intercom. The call will ring, or for an ICM Vo
Announce call, a splash tone
Voice Announce is
the called station bu
Announce call will ring or a ringing ICM call will al
Voice Announce (toggle).
Selection/Busy Lamp Field (DSS/BLF)
button allows you to call another station with the single
er
When you go off-hook, you may connect to another
station or sy sou matically. This Prime
L ere y be ate or delayed allowing
y ke tion the delay. Otherwise,
y pre ther utton before going off-
hook to overr e Li rence.
If off-hook and ta tion, Intercom dial-tone
w out ter ler tone is received,
yo e plac n Intercom
L t; y mus p to return the phone
to sta
4.1.1 Using Camp-On when calling a busy station
the called party is busy, you may activate Camp-On,
allback or Voice Over at the station. Camp-On
allows you to wait off-hook for the called station to
answer. Callback allows you to hang-up, and when the
busy station returns to an idle state, the system will call
of a button. The button LED will display the oth
station’s status (ON=busy, OFF=idle).
stem re
4. Placing Calls
rce auto
ine Pref nce ma immedi
ou to ta other ac s during
ou may ss ano Flex b
ide Prim ne Prefe
you go ke no ac
ill time- , and af
will be
the How
ur phon ed out-of-service i
uock-Ou ou then t hang-
an idle te.
To place an Intercom call:
• Lift the handset,
• Dial the In num f the sired station,
• When the c nswered or the Splash tone is heard,
begin speaki
tercom ber o de
all is a
ng with the called party.
If
C