User's Manual Part 1

RBS 2109 User’s Guide
5.4.2.1 Installing the Wall Bracket on a Wall (Alternative)
1
Place the drilling template in the position where the RBS is to be
located.
2
Use a spirit level to check that the drilling template is horizontal.
3
Mark the position of the holes to
be drilled.
Note: The wall bracket must not
be used as a drilling template,
to avoid damaging the rust
protection surface.
P010150B
DRILL TEMPLATE FOR WALL BRACKET
Recomended holes
UP
Alternate holes
4
Remove the template and drill the holes for the fasteners.
5
Install the wall bracket and
secure it in position with all the
screws provided.
UP
P010151A
6
Loosen the four nuts, on which the MBU is to be hung, until only a few
threads remain exposed.
5.4.2.2 Installing the Wall Bracket on a Pole (Alternative)
1. Choose the appropriate holes. See Figure below.
4
4
E
N/LZT 720 0090 Uen R1A 2004-09-17