User's Manual Part 1

RBS 2109 User’s Guide
P010170B
Recess
Figure 20 Installing the Wall Bracket on the Pole
5.4.3 Installing the MBU
This section describes how to install the Mounting Base Unit (MBU) on a wall or
wall bracket.
5.4.3.1 Installing the MBU on a Wall
1
Place the drilling template in the position where the RBS is to be
situated.
2
Use a spirit level to check that the drilling template is horizontal.
3
Mark the position of the
applicable holes to be drilled.
Note: To avoid damaging the
rust protection surface, the MBU
must not be used as a drilling
template.
P010234B
DRILL TEMPLATE FOR WALL BRACKET
Recomended holes
UP
Alternate holes
4
Remove the template and drill holes for the fasteners most suitable
for the wall material.
5
Insert the fasteners and tighten them, remembering to leave enough
threads protruding to hang the MBU on.
4
6
E
N/LZT 720 0090 Uen R1A 2004-09-17