Reference Manual

Filter for External Batteries DC Filter for RBS 2106
Ericsson AB
SE-164 80 Stockholm
Sweden
[e-mail]
Due to continued progress in methodology, design and manufacturing,
the contents of this document are subject to change without notice.
© Ericsson AB
4 (4) EN/LZT 720 0302 R1A
The DC Filter serves as an EMC barrier against the outside electrical
environment and a mechanical barrier against the outside climatic
environment.
4 Interface
4.1 Signal and Power Interface
The DC Filter has the following external interfaces:
• Two input terminals for 70 – 185 mm
2
cables. The input terminals are of
semi-enclosed clamp type.
• Strain-relief clamps for cables with diameter 14 – 26 mm.
• Output cable negative (-) is a 70 mm
2
cable, about 420 mm long, with an
Anderson power plug.
• Output cable positive (+) is a 70 mm
2
cable, about 420 mm long, with an
Anderson power plug.
• A hole for an optional temperature sensor connector is provided.
Voltage and current
Table 2 Limiting values
Rated voltage 100 V DC
Feed-through current 175 A