User's Manual Part 2

RBS 2308 and RBS 2309 User’s Guide
Note: For OMT Version R31 and later, the OMT parameters are also included
as on-line help.
Work Process for Setting IDB Parameters
This section describes the work process for setting the IDB parameters.
Defining TEI
Defining TNOM
Installing IDB
P012515C
Defining PCM
Defining External Alarms
Defining Hardware
Info for Passive Units
Defining Delay
Defining
GPS Parameters
Defining Loss
Defining RBS Identity
Reading IDB
Connecting the OMT
Creating IDB Opening IDB from File
Start
Figure 50 IDB Parameter Setting Work Process
If IP is selected as the t
ransmission interface, then the two OMT dialog boxes
Defining PCM and Defin
ing TNOM are not accessible.
Note: The IDB parameter values required are found in:
1
15
EN
/LZT 720 0027 Uen R8A 2006-06-27