User's Manual Part 2

RBS 2308 and RBS 2309 User’s Guide

Table 40 Selecting

Section for Defining T1, Without any Information about

the Cable Length

If...

Then...

there is no information about the

cable length

go to Section Defining LBO Parameters when

Transmission Ch arac te ristics are Unknown

on Page 138.

Note: Calculating the total attenuation of the entire R BS chain is only

necessary if multidrop (in combination with OVPs with bypass relays)

is used.

Defining LBO Parameters as Short Haul

This section describes how to define the LBO parameters as short haul.

1. On the Co

nfiguration menu, click Define and PCM to open the Define

PCM wind

ow.

2. Set the parameters according to the table and instructions below.

3. Cl

ick OK when all parameters are set.

Table 41 PCM parameters Settings for Transmission Interface T1, Short Haul

PCM Parameter Setting

Transmission Interface DS1(T1)

Network Topology

See Site Installation Documentation

Sync Source See S ite Insta lla tion Docu m entation

LBO A

LBO B

LBO C

LBO D

See instructions below

FDL U se

See Site Installation Documentation

The instructions below describe how to calculate the LBO parameters.

Note: Ports C and D can also be used as a multidrop pair.

P008645B

Customer

Interface

DSX-1

RBS 2 RBS 3RBS 1

A(C) B(D)

Figure 55 System View for Transmission Interface T1, Short Haul

130

EN/LZT 720 0027 Uen R8A 2006-06-27