User's Manual Part 2

RBS 2308 and RBS 2309 User’s Guide
7.8 Testing External Alarms
This section describes how to use the OMT to test that all external alarms, if
used, are recognized and handled correctly. The test is passed when all alarms
are recognized.
Note: The alarms must be individually identifiable in the OMT. There must
be no doubt which alarm was indicated. The alarm message must
be unique for each alarm.
1. On the Maintenance menu, click Monitor to open the Monitor window.
See figure below.
P010475A
Figure 60 Testing External Alarms
2. In the Available monitors box, select “External Alarm Status” and click  to
add “Alarm Inlets” in the Monitors to start box.
3. Click Start monitor.
142
EN/LZT 720 0027 Uen R8A 2006-06-27