User's Manual Part 2

RBS 2308 and RBS 2309 User’s Guide
2.
Remove the sunshields covering the RBS.
3.
Open the two clasps and pull the
Remote Radio Unit (RRU) to the
left.
P010396A
4.
Open the Interface and
Switching Unit (IXU) cover.
P010357B
5.
Connect the serial cable from the serial port of the local terminal to the
console port of the PSTU, as shown in the figure below.
The termination blocks for ports A–D are never used together with a
PSTU and can thus be temporarily or permanently removed to make
room for the serial cable.
Note:
The connector of the serial cable has a metal frame that can short-circuit
elect
ronic equipment in the RBS. It is recommended that the connector
be cov
ered with insulation tape before connecting it to the PSTU.
152
EN/LZT 720 0027 Uen R8A 2006-06-27