User's Manual Part 4

RBS 2308 and RBS 2309 User’s Guide
8.
Open the IXU cover and remove
the faulty Y-link cable from the
IXU.
P010357B
9.
Connect the new Y-link cable to the IXU and close the cover.
10.
Switch on the RRU power and close the RRU.
Putting the
RRU into Service
11.
Inform the OMC operator that the RRU is to be put into service.
12.
Press the Local/Remote button on the RRU to set the unit to remote
mode. Wait until the R F off indicator on the RRU interface panel goes
off and the Operational indicator lights up.
13.
Close the sunshields.
10.5.13 Performing Concluding Routines
This section describes the routines to be completed before leaving the site.
Sorting and Recycling
Note: Ericsson strongly advises that when cleaning up after maintenance
work on the RBS cabinet, the personnel performing maintenance pay
particular attention to the environment. Recycle all waste materials that
can be recycled and sort waste so that it can be disposed of according
to local regulations.
252
EN/LZT 720 0027 Uen R8A 2006-06-27