User's Manual Part 4

RBS 2308 and RBS 2309 User’s Guide
1) Prepared 2) Telephone No.
5) Country
code
6) Exchange code 7) State code 8) Consecutive No. 9) Cellsite No. 10) Sector No.
11) Product No. 12) R-state 13) Channel No. 14) Software application
15) Function description 16) Fault code
17) Factory code 18) Serial No. 19) Manufact. (year, week) 20) Description of fault
21) Superior product No. 22) R-state 23) Serial No.
24) Sender 25) Receiver
27) Reference No. 28) Received
26) Remarks/special instructions
3) Failure date (yyyy-mm-dd) 4) Failure
Suspected Verified
29) Date (yyyy-mm-dd)
REPAIR DELIVERY NOTE
Instructions on reverse side
LZF 084 84 /1EN R1A
P005537C
Eric Ericsson
[phone]-08-16
x
S E
H W S
KRC 123 456/1 R1A
LZY 213 938/1 R7/1
A5304AQ41B 9714
Fault indicated 2 hours after power on
outdoor temp 40
o
C
RBS 2102
Installed 1998-10-15, logfiles on paper included
The following fields are mandatory. Use block letters.
1 Prepared Service technician´s name
2 Telephone Service technician´s telephone number
3 Failure date
4 Failure Mark with an X if failure is Suspected or Verified
5 Country code Two letter country code
7 State code Hardware (HW) status when failure occurred:
S = Unit in service when failure occurred (Repair)
T = New unit failed during installation or test (Claim)
R = Repaired unit failed during installation or test (Claim or Repair)
11 Product No. Faulty unit
12 R-state Faulty unit
14 Software RBS load, product number and R-state
application
16 Fault code Check OMT or work order
18 Serial No. Faulty unit
19 Manufact.
(year week)
20 Description Observations and external factors
of fault
21 Superior RBS type
product No.
24 Sender Customer, Company, Corporate ID
26 Remarks/special Information about installation date, logfiles and modification requirements
instructions
SO TRXC RU0, SO TRXC I1A10
MMO/EDD/EDDERER
Figure 91 Example of Completed R epair Delivery Note (Blue Tag)
The above explanations to the Repair delivery note are also given on its
reverse side.
10.6.2 Cleaning the Units
To ensure that repair personnel is not unnecessarily exposed to contamination
risks, all outdoor units must be cleaned before returned to the repair c entre.
A label must be attached to the cleaned unit. The label must specify the
cleaning method used and the name of the person who performed the cleaning,
including phone number or other contact details.
256 EN/LZT 720 0027 Uen R8A 2006-06-27