User's Manual Part 4

RBS 2308 and RBS 2309 User’s Guide
Note: Do not connec
t the Ethernet cable connectors to the PSTU yet. If the
PSTU contains a con
figuration from previous use, then connecting the
Ethernet cables ca
n generate conflicting IP traffic.
2.
Reinstall the connection frame.
3.
Optical Ethernet:
Pass the optical Ethernet cable
through the most suitable cable
inlet, so that about 20 mm of
the cable sleeve protrudes into
the PSTU, and tighten the cable
gland.
P015754A
Electrical Ethernet:
• For cables with factory-fitted
connectors: remove the split
rubber grommet from the slot
to the right of the cable inlets,
choose a cable of suitable
diameter from the parts supplied
with the P STU, attach the seal
to the cable and press it back
into the slot.
• For cables without factory-fitted
connectors: pass the cable
through the most suitable cable
inlet and tighten the cable gland.
P015755B
4.
Seal any unused cable inlets.
Note: Do not connect the Ethernet cable connectors to the PSTU yet. If the
PSTU contains a configuration from previous use, then connecting the
Ethernet cables can generate conflicting IP traffic.
11.3.6 Changing IDB Parameters
To change Installation Database (IDB) parameters, first switch on the AC power
and DC power to the RBS.
266
EN/LZT 720 0027 Uen R8A 2006-06-27