Reference Manual

BTS Parameter Limitations
58 BTS Parameter Limitations
This document specifies configurable BTS parameters with limitations
compared with the parameter ranges in the Abis O&M IWD. BTS
parameters with no limitations compared to the Abis O&M IWD are not
stated in this document.
58.1 Purpose and Readers
The purpose is to show BTS parameters with parameter range
limitations compared to the Abis O&M IWD.
People involved in the preparation of data transcripts for the BSC are
the target group of this specification.
58.2 References
•
6/155 19–HSC 103 12 Uen
Abis O&M Interface, Part II, Procedures
• 5/155 19–HSC 103 12 Uen
Abis O&M Interface, Part I, Model
•
3/1551–APT 210 09 Uen
Translation of Abis O&M IWD Parameters - BSC Command
Parameters
58.3 Parameters
The parameters listed in this document are extracted from the Data
Elements listed in the Abis O&M IWD document (see reference 1).
This document states the BTS parameters with parameter range
limitations compared with the Abis O&M IWD.
For each parameter in the list, the range supported by the BTS and the
Abis O&M IWD is stated.
All coding in the document is in hexadecimal (hex) representation if
nothing else is stated.
Note: See reference 3 for BSC Commands.
58.3.1 Accordance Indication
BTS-supported value range:
AIP: 0 – 1, 3
IWD-defined value range: 0 – 3
58.3.2 Alarm Status Type
BTS-supported value range:
Alarm status type: 1
IWD
EN/LZT 720 0008 P2A
2001-11-28
461 (485)
© Ericsson Radio Systems AB
— All Rights Reserved —
Preliminary