AP 6321 Quick Install Guide QUICK GUIDE 1/006 92-LZA 101 822 Uen D
Copyright © Ericsson AB 2013. All rights reserved. No part of this document may be reproduced in any form without the written permission of the copyright owner. Disclaimer The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document. Trademark List Wi-Fi® Wi-Fi® is a registered trademark of the Wi-Fi Alliance.
Getting Started 1 Getting Started 1.
AP 6321 Quick Install Guide Contact your Ericsson representative for more information. 1.2 Unit Description 1.2.1 Power Connector The unit does not have a power switch. It is powered on when connected to a power source. The power adapter, ordered and shipped separately, automatically adjusts to any voltage between 100~240 volts at 50 Hz or 60 Hz. The unit draws up to 0.43 A at 48 V DC (20.9 W).
Getting Started 802.3at Power Source Equipment (PSE) Specification: • 50.0 to 57 V DC, with 30 W output power from the PSE 802.3at Powered Device (PD) Specification: • 42.5 to 57 V DC at the PD, with 25.5 W maximum input power to the PD 802.3at Cable Specification: 1.2.3 • 100 m maximum length • Maximum cable pair resistance of 12.
AP 6321 Quick Install Guide 2 Installing the AP 6321 2.1 Step 1—Select Location Choose a proper place for the unit. In general, the best location is at the center of the intended wireless coverage area, within line of sight of all wireless devices. For optimum performance, consider these guidelines: • Mount the unit as high as possible above any obstructions in the coverage area.
Installing the AP 6321 2.2 Step 2—Mount on a Flat Surface Mount the unit only on a flat surface that is at least 1/2-inch (12.7-mm) plywood or the equivalent. To mount the unit on a ceiling or a wall, use one of the following options: • To mount the unit on a wall or on a ceiling that does not have T-rails, use the pan head Phillips screws provided with the unit.
AP 6321 Quick Install Guide • For a suspended ceiling in which the tiles are flush with the T-rails, attach the appliance feet provided in the Ceiling Tile Hanger Kit. 3. Attach the unit to the mounting points on the mounting bracket by doing the following: 2.3 a Line up the two mounting slots on the bottom of the unit with the two mounting points on the mounting bracket. b Slide the unit across into position so that the mounting points support the unit.
Installing the AP 6321 Caution! Use ONLY the Ericsson power adapter for the AP 6321. Use of any other power adapter can damage the unit and voids the Ericsson product warranty. Figure 2 Power over Ethernet Warning! If PoE is used, the AP 6321 must be connected to a power source that complies with IEEE 802.3at, or to an IEC/EN 60950-1 compliant power limited source. 2.4 Step 4—Check Indicators All indicators are illuminated for about one to two seconds when the unit is powered on.
AP 6321 Quick Install Guide Indicator (OPERATIONAL) Behavior Green 2.4G Green 5G Green (INTERNET) Green If the indicator behavior does not match Table 2, refer to the AP 6321 Technical Description, 1/1550-LZA 101 822 for detailed indicator descriptions. 2.5 Step 5—Configure Unit In most cases, the unit configures itself automatically after powering on.
