Installation Instructions

COMMISSIONING PROCEDURE 17 (23)
BRU1 MANUAL, Doc.no: b1commis Uen Rev PA5, 2004-02-20
TASK0: Enter protocol HDLC/X25/MASC/BIU for unit 0
Enter . to ignore
_Enterprotocol: > X25
_OK?(Y/N) > Y
CFG_DB: Delete CONFIG_DB
6. Press <RETURN> when the system prompts you to enter user name and
password (they are not required at this stage).
7. Verify that the slave unit has started.
NODOP> LIST UNIT
The status of the unit should be Running.
8. Establish (create) a connection to the superior node. The connection will
automatically be enabled after it has been created.
Example:
NODOP> CREATE SUPERIOR_CONNECTION [superior node]
9. Examine if the connection to the superior node works by issuing the
command:
NODOP> SHOW CONNECTION [superior node]
10. Tell the NCC operator to DISTRIBUTE a proper config to the node, to
perform the on-line operation UPDATE SW, and to RESTART the node.
11. When you are prompted, enter !!! on the console port and set the virtual
thumb wheel to position 0.
12. Set the console printouts on:
NODOP> SET CONSOLE ON
13. Wait until a screen message indicates that the new NSV (Node Software
Version) is permanently installed.
Examine if the NSV is permanently installed by issuing the command:
NODOP> SHOW BOOT_SOURCE
14. Run the command
NODOP> SET CONSOLE OFF
15. Terminate the NODOP session by issuing the <LOGOUT> command.