Installation Instructions
Table Of Contents
- Commissioning Procedure
- 1 General
- 2 Hardware Commissioning
- 3 Part A - Installation Inspection
- 4 Part B - Power Test
- 5 Part C - Transmitter Test
- 6 Part D- Hardware Alarms
- 7 Part E- LED indicators
- 8 Before Leaving the Site
- 9 Software Commissioning
- 10 Commissioning Procedure
- 11 Before Leaving the Site
- Appendix 1 Downloading New MAIN NTE SW to a BRU1 Node
6 (23) BRU1 MANUAL
BRU1 MANUAL, Doc.no: b1commis Uen Rev PA5, 2004-02-20
3 Part A - Installation Inspection
For more site-specific information, please refer to the BRU1 - Site
Documentation.
A1 Make sure that the site is clean and not damaged.
A2 Make sure that the BRU1 is correctly mounted in accordance with the
installation instructions given in Node Hardware Library/BRU1/Site
Requirements and Installation Instructions.
A3 Verify that the delivered equipment and serial numbers correspond to the
specifications in the BRU1 - Site Documentation.
A4 Make sure that the combined Rx/Tx antenna is installed.
A5 Make sure that the required power supply cable is correctly installed.
A6 Make sure that the connection line cable is correctly installed.