User`s guide

18(54)
Datum/Date
Rev
Dokumentnr/Documentnr
Uppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked
Tillhör/Referens-File/Reference
99-07-15 U
155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
6 FUNCTIONALITY OF ASB 150 02
WITH / WITHOUT CONNECTED FECU
Together with the introduction of the ASB 150 02 R9, a software licencing concept was introduced.
Most of the features which are introduced from the Software Release ASB 150 02 R9 upwards can only be enabled
by a hardware device, the so called "Feature Enabling Circuit Unit" (FECU), which is connected to the CPU-D4.
Each major commercial release (e.g. BusinessPhone 250 / BusinessPhone 50 Version 3, Version 4, ...) has its own
FECU series, covering several packages.
BusinessPhone 250 / BusinessPhone 50 - Version 3 ( ASB 150 02 R9, R10 )
FECU article number: KDUBS 130 06 / x ( x = Package 1-10 )
Package 1: Basic Fucntions R9, R10
Package 2: Standard digital networking ( QSIG + VPN ) with max. 32 interfaces
Package 3: Standard digital networking ( QSIG + VPN ) with unlimited interfaces
Package 4: Full digital networking ( QSIG + VPN + UUS ) with max. 32 interfaces
Package 5: Full digital networking ( QSIG + VPN + UUS ) with unlimited trunk interfaces
Package 6: CTI
Package 7: Standard digital networking ( QSIG + VPN ) with max. 32 trunk interfaces + CTI
Package 8: Standard digital networking ( QSIG + VPN ) with unlimited trunk interfaces + CTI
Package 9: Full digital networking ( QSIG + VPN + UUS ) with max. 32 trunk interfaces + CTI
Package 10: Full digital networking ( QSIG + VPN + UUS ) with unlimited trunk interfaces + CTI
BusinessPhone 250 / BusinessPhone 50 - Version 4 ( ASB 150 02 R11 )
FECU article number: KDUBS 130 07 / x ( x = Package 1-10 )
Package 1: Basic Fucntions R11
Package 2: Standard digital networking ( QSIG ) with 32 interfaces
Package 3: Standard digital networking ( QSIG ) with unlimited interfaces
Package 4: Full digital networking ( QSIG + VPN + UUS ) with 32 interfaces
Package 5: Full digital networking ( QSIG + VPN + UUS ) with unlimited interfaces
Package 6: Full digital networking ( QSIG + VPN + UUS ) with 4 interfaces + CTI
Package 7: Standard digital networking ( QSIG ) with 32 interfaces + CTI
Package 8: Standard digital networking ( QSIG ) with unlimited interfaces + CTI
Package 9: Full digital networking ( QSIG + VPN + UUS ) with 32 interfaces + CTI
Package 10: Full digital networking ( QSIG + VPN + UUS ) with unlimited interfaces + CTI
Features which were introduced in a Release earlier than ASB 150 02 R9 are always enabled, and therefore also
accessible if no FECU is connected to the CPU-D4. Furthermore fault corrections to existing unprotected features,
as well as small feature improvements are always enabled.
Only two features are excluded from this philosophy: These are the "BusinessLink for Novell" and "proprietary CTI
Interface", which were introduced in ASB 150 02 R8. To run the "BusinessLink for Novell" and "proprietary CTI
Interface" on the system with R9 Software or upwards, the related FECU (see following table) is required.
The Package 1 always represents the new basic functionality of the Release, which is of course also included in all
packages with a higher index.
If you upgrade a system to a higher SW-Release, without changing the FECU although the new Release has its own
FECU series (separate article number), the system will remain on the same feature level, except for those features
that are unprotected.