User`s guide

2(4)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
120/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Limitations
Background music does not seize (occupy) any traffic
function key.
When an incoming call is presented or on initiation of a
call, background music will be disconnected
automatically.
Background music returns immediately when the
telephone has returned to idle state.
Only external connected audio equipment can be
assigned as background music source.
Programming
Note:
For ASB 150 02 systems up to R10:
to activate the programming the system has to be
restarted !
For ASB 150 02 systems starting from R10:
restart of system after programming is not necessary
anymore.
5404
Create background music
This command creates a music channel for
background music by assigning it a vacant directory
number that does not conflict with existing directory
numbers, see command group 56.
Command 3601 determines how the music source is
to be physically connected to the exchange.
Command 5403 creates a music channel, which may
be utilised for background music as well as music for
camped-on parties.
3601
Sources for music
Sources for music-on-hold or background music are
connected either to trunks reserved for this purpose or
the analogue port on the CPU-D board. This command
defines a link between a music source and a call
number. If the music-source is the analog port on the
CPU-D board, the call number is D#00.
If no link is defined, a parking tone is supplied instead
of music.
Removal of a music source is done by pressing the
dial key to erase the call number.
Before this command can be used, the commands for
background music (5404) or music-on-hold (5403)
must have been initiated. The trunk used for music
shall be programmed for "no transmission" (command:
1302) and "no PTS signal from parent exchange"
(command: 1307).
Range of values: 0 - 9999 for trunk lines.
D#00 The analog input on the CPU-D board.
1302
Outgoing digit transmission
The command states how the digits are sent from the
interworking exchange. The initial value depends on
the type of the BTU .
Set this command to "no transmission".
1307
PTS-signal from PE ?
The command is used to state whether the exchange
is to wait for a proceed-to-send signal (PTS signal)
from the parent exchange.
Set this command to NO.
5504
Delete background music
This command will delete a music channel used for
background music.
Command 5503 deletes the music channel which is
utilised for background music as well as for music for
camped-on parties.
5611
Alter background music
If you want to change the number to a new number
that is in conflict with the old number, this cannot be
done directly. In such cases first change to a random
free number and then change to the desired number.