User`s guide

3(4)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 F
120/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
However, references to previous numbers will remain.
These references are deleted or substituted by the
new number.
If no number is indicated, an error message will be
displayed, since the directory number is the only
identity of the music channel, and therefore must not
be deleted. To delete a music channel from the
system, see command group 55.
5806
Show background music.
This menu displays a survey of all defined directory
numbers for music.
KEY FOR BACKGROUND MUSIC
If a special key for connection/disconnection of the
function is required it will be necessary to program a
name selection key.
See also under "NAME SELECTION",
document 360/155 34-ASB 150 02 Uen.
0301
Function of the programmable key
This menu shows the function of the progammable
keys for the selected extension.
xxxx indicates irrelevant information for selected
function of the key.
This command states which function a key is to have.
For some key functions it is possible to program an
associated number, how incoming calls are to be
presented and ACD-group priority.
If an extension is programmed as a guest extension,
(command 0118) or as a data extension, (command
0130) key 0 is used as wake-up key and data line
respectively. In this case it is not possible to alter the
function of key 0.
Note, however, that these functions cannot be entered
with command 0301.
0302
Number associated with the key
This menu shows the function of the progammable
keys for the selected extension.
xxxx indicates irrelevant information for selected
function of the key.
This command states the number that is to be
associated with a programmable key. A number may
be associated with the following key functions:
Name selection: One 1-4 digit number. The number
may consist of digits,*,# (and wait
for second dial tone)
Post dialing: One 1-4 digit number. The number
may consist of digits,*,# (and wait
for second dial tone)
Trunk line: Trunk line directory number
Supervision: Directory number of supervised
extension
Dedicated intercom: Directory number of other
extension
Voice paging: Serial number of paging group, 0-7
ACD-group: Serial number of ACD-group, 0-7
ACD-monitoring: Directory number of monitored
ACD-operator
Trunk line data
Program the following commands with the stated value
for the trunk line used.
1201
Line signal scheme
The command is used to select the line signal table.
The selection is based on the type of interworking
exchange connected. The initial value of the line signal
table used, depends on type of BTU and market
version.
Enter new value = 1
Equipment
Background music requires an external music source
and an analogue trunk (BTU-A_) per music source. If
the background music uses the same source as