User`s guide

3(8)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
98-05-29 D
140/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Programming
Following commands are only accessable via
RASC:
A number of parameters has to be programmed, in
order for the output to the connected external
equipment to function for individual desires.
• Output criteria to determine which types of calls
that are to be printed out.
• Communication channel for outputs
• Format for outputs
OUTPUT CRITERIA
You can program which types of calls that are to be
registered and printed out. The following types can be
programmed:
• Internal calls
• Incoming external calls
• Outgoing external calls
You can also determine if the output is to take place
after a certain call time, or after the reception of a
certain number of meter pulses / costs.
The output can also be made dependent on the first
digit in the external number.
6201
Log internal calls ?
This command is used to determine whether all
internal calls in the PABX are to be logged or not.
6202
Log incoming calls ?
This command is used to deterime whether all
incoming external calls are to be logged or not.
6301
Log outgoing calls ?
This command is used to deterime whether outgoing
external calls are to be logged or not.
6302
Log duration time
This command can be utilised if it is desired to log
outgoing external calls (see command 6301), but
exclude "short" calls.
The command is used to set a minimum call duration
time for an outgoing external call to be logged.
Further prerequisites can be defined for determining
which outgoing external calls shall be logged, see
commands 6303 and 6306-6315.
With the minimum call duration time = 0000, outgoing
external calls will be logged irrespective of call
duration.
Value = mmss mm = 00 - 59 min
ss = 00 - 59 s
6303
Minimum number of meter pulses for logging
This command can be used if it is desired to log
outgoing external calls (see command 6301), but
exclude those calls that have incurred "few" meter
pulses.
The command is used to determine the minimum
number of meter pulses required for an outgoing
external call to be logged.
Value = 0 - 9999 meter pulses
Further prerequisites can be defined for determining
which outgoing external calls shall be logged, see
commands 6302 and 6306-6315.
With the minimum number of meter pulses = 0000,
outgoing external calls will be logged irrespective of
the number of meter pulses.