User`s guide

2(18)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 D
141/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
OPERATION
Reception of metering information
Metering information may be received by analogue
and digital trunks.
Network providers make metering information
available in the form of call-metering pulses or call
charges. Analogue trunks send call-metering pulses.
Digital trunks can transmit call-metering pulses or
costs.
At analogue interfaces suitable call-meter receivers
are necessary for the reception of call-metering
pulses.
Conversion and storage of metering
information
The received call-metering pulses are converted into
costs by means of a conversion factor (costs/pulses).
ASB 150 02 stores costs and pulses. Costs may be
displayed in local currency. A three-figure abbreviation
of the local currency may be placed before or after the
amount of costs.
Call information during the call
It is possible to display current call information during a
call:
• Costs
• Number of call-metering pulses
• Conversation time
• No indication
If the desired indication is not available, ASB 150 02
automatically goes back to the next possibility, e.g.
instead of call-metering pulses the conversation time is
displayed (e.g. for a tie line, where information about
pulses or costs is not provided).
Information is updated every 15 seconds.
Activate and deactivate
The indication of the call information may be activated
or deactivated with the following function code.
• Dial * 41 #
The setting is valid until the function code is entered
once again.
Activate and deactivate function for current call
This function may be used by pressing the menu keys
of system telephones DBC 213 and DBC 662.
The menu key F4 – "cost-off“ / "cost-on“ (DBC 662:
"coff“ / "con“) – activates and deactivates the display of
the costs.
This setting is only valid for the current call. At the next
call, the display again has the setting defined by
command * 41 #.
Last call charges
After termination of the call you may query the costs of
the call.
The display shows the costs.
If no cost information has been available during the
call, no last call charges will be displayed (e.g. in case
of tie line calls).
Operation
• Use function code * 46 # (or the corresponding
programmed name selection key).
• For return to idle state, press key C (Clear) or the
menu key "return“.
Operator supervised call
Charges for calls, established for extensions via the
operator may be displayed at the operator console
after the extension terminates the call.
14. Apr. 12.30
LAST CALL: ATS 123.45
return