User`s guide

11(18)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 D
141/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
6103
Set hour minute second
Press Enter
Enter time: Format: hhmmss
6104
12h mode, display
You may enter the time in 12- or 24-hour-mode.
(Independent of this programming, entering the time at
a telephone is always done in the 24-hour mode, e.g.
at wake-up call, reminder, setting of time.)
z Enter the relevant function:
Y= 12-hour mode
N= 24-hour mode
Type of call metering
The following commands are only accessable via
RASC:
1029
Tenant group
With this command we assign a tenant group is
assigned to a trunk. The value of the tenant groups
ranges between 0 and 15.
The trunk tenant group is used for cost calculation for
outgoing calls.
1501
Initiation of call meters
This command states whether call-metering pulses
shall be received. The function call metering
necessitates that (1) the analogue trunk is equipped
with call meter receivers or (2) the signal diagram of
the digital trunk includes the function call metering.
1502
Tariff number
This command defines the call-metering tariff number
for the specified trunk.
Values: 0-5, not programmed
Default: not programmed
1503
Carrier number
This command defines the carrier number wired to the
specified trunk.
Values: 0-7
Default: 0
Type of call meter receiver and level
1607
Call meter type
This command states the type of the call meter
receiver (12 kHz or 16 kHz). Call metering with 50 Hz
call meters and a digital trunk is not affected by this
command.
1608
Call meter receiver level
Command 1608 is valid for call meter receivers CM 16
(ROA 219 5062/1) and CM 12 (ROA 219 5062/2). This
command states the minimum level for recognition of
call-metering pulses.
14. Apr. 12.20
SET HOUR MIN. SEC. 6103 >
backward forward return
14. Apr. 12.20
12 H,DISPLAY MODE 6104 z
backward forward return