User`s guide

4(7)
Datum/Date Rev
Dokumentnr/DocumentnrUppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked Tillhör/Referens-File/Reference
99-07-15 E
165/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Fictive Numbers
To order/cancel diversion
Programmable via RASC, see FICTIVE NUMBER,
document 201/155 34-ASB 150 02 Uen.
Capacity
Only one divertee (answering) position per directory
number can be programmed.
This divertee position must be the same as used for
the functions diversion on no reply and diversion on
busy.
Limitations
Calls that have been presented already are not
affected on activation of diversion.
Calls via external line keys or intercom lines are not
affected by diversion.
An extension with ongoing diversion that is a member
of an extension (PBX) group will be marked absent
from the group.
A call that has already been diverted once is not
affected by diversion direct.
It is only possible to activate Diversion while the
telephone is in idle state.
No support of S-bus terminals as diversion address,
because they are dedicated to be trunk individuals.
Display call-forwarding status on idle instrument
It is not possible to show all information on the display.
Therefore some kind of priority is defined. The
following list shows the priority starting with the highest
priority at the top to the lowest priority at the bottom:
• Info display
• Direct diversion
Programming
0109
Direct diversion?
This command represents the actual state of the
diversion key on the instrument.
xxxx Enter extension's directory number
z Enter relevant function:
Y = Yes
N = No (default data)
To activate the diversion-key, check if diversion is
programmed for incoming external calls (see
command 0156) or / and internal calls (see command
0159).
Then step to command 0112.
10 Jul 14:40 +15˚
DIRECT DIVERSION ? 0109 xxxx z
backward forward c/i return