User`s guide

9(31)
Datum/Date
Rev
Dokumentnr/Documentnr
Uppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked
Tillhör/Referens-File/Reference
99-07-15 C
265/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
2. Go to the directory in which the Cordless System Software has been installed.
3. In most cases, you can start the Cordless System Software by just typing DCT <Enter>.
You may also use command line options:
DCT /OFFLINE. Starts the Cordless System Software in Off-line mode.
DCT /B<bit rate>. Example: DCT /B9600. This option allows you to change the bit rate with
the Desk Charger/Programmer. This may be useful when you want to down-load software
to Portables with a higher (non-default) bit rate. Valid bit rates are: 4800 (default), 9600,
19200 and 38400. Consult your PC documentation to check which bit rates are supported
for the COM2 port.
4. When the program has correctly started-up the welcome menu containing the name of the program
is displayed.
Now the password of the Distributor, the System Manager or the Receptionist may be typed.
Depending on the password which has been entered, the Distributor, System Manager or Receptionist
menus are displayed.
If the system is not initialized, the Distributor has to follow the procedure as described in the following
chapter.
Initialization and Making the System Operational
Introduction
Once the system has been assembled it must be made operational. Therefore, a number of system
parameters in the IC-CU_ must be initialized and also the Portable Telephones have to be programmed.
Initializing the IC-CU_ can only be done by the Distributor. Programming Portable Telephones can be
done by the Receptionist or the Distributor.
When the preparations have been carried out the Cordless System Manager starts an initialization
process. This initialization process will successively invoke a number of commands and screens. Enter
the required parameters and then get the system operational.
Initializing the Integrated Cordless System
Password Distributor
The ’Password Distributor’ screen asks you to fill in the password of the Distributor. The ’default’
Distributor's password is factory-set. It must be communicated to you when the system is delivered.
Country Selection
The Country Selection screen asks you to specify the country where the system is installed.
Please choose any value.
Ringing Cadences
Three screens specify the ringing cadences for Int. Calls, External Calls, and Call Back ringing types.