User`s guide

16(31)
Datum/Date
Rev
Dokumentnr/Documentnr
Uppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked
Tillhör/Referens-File/Reference
99-07-15 C
265/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
Internal call, external call, call back and custom ringing
Menu path: Receptionist - Administrate - Ringing - Internal call/External call/Call back
Menu path: Distributor - Administrate - Ringing - Internal call/External call/Call back
These commands allow you to adapt the ringing cadences that have been programmed into a cordless
phone. In this way the cordless phone can be programmed with personal ringing cadences. To carry out
this command, the cordless phone must be in initialization mode.
Cordless phones know the following ringing types:
Type 1 Internal call.
Type 2 External call.
Type 3 Call back.
Types 4 to 8 Custom types (reserved).
Note:
The custom cadence settings are reserved for future use and are not described here.
A cadence is set by specifying the ON and OFF times on the screen for each ringing type. The first not
empty field (an empty field is a field filled with blanks) in an ON time field is evaluated as the first ON
time. At least one ON and one OFF field must be filled in.
The ON/OFF times are presented in milliseconds. The minimum value is 0 milliseconds, the maximum
value is 5000 milliseconds.
The maximum number of times that can be entered for one cadence setting is 40. The maximum
number of all times, for all 8 cadence settings is 115.
Find on IPEI (GAP only)
Menu path: Receptionist - Administrate - Find IPEI
Menu path: Distributor - Administrate - Find IPEI
This command allows you to locate the owner of phones which have been lost or misplaced and then
returned to the system administration centre by a third party. Entering the IPEI number of the misplaced
phone will display a further screen which shows the extension number and TPUI number of the owner.
Add Base Station
Menu path: Distributor - Base Station - Add
This command defines a new Base Station in the IC-CU_ data base. A Base Station is defined by its
controlling circuit on the IC-LU or IC-CU2 board and its cable delay value.
Board Address: - Cabinet Number.
- Board Number. Defines the position of the IC-LU within the Cabinet.
The numbering of the Board Numbers is in following way:
Slot number of cabinet 0 1 2 345678
Board number 24 28 32 36 40 44 48 52 56