User`s guide

22(31)
Datum/Date
Rev
Dokumentnr/Documentnr
Uppgjord/Prepared
Dokansv/Godkänd - Doc respons/Approved Kontr/Checked
Tillhör/Referens-File/Reference
99-07-15 C
265/155 34-ASB 150 02 Uen
FACILITY DESCRIPTION
Faktaansvarig - Subject responsible
System Manager Menu
Password
Menu path: System Manager - Password
This command changes the System Manager's password. Two different situations can be distinguished:
- You are logged in as Distributor or,
- You are logged in as System Manager.
So, the System Manager's password can be changed by the Distributor and by the System Manager
himself.
The Distributor may give the System Manager a new password if he has forgotten the old one. The
Distributor does not have to know the old password of the System Manager, due to his higher authority
level. He must enter his own password and subsequently change the System Manager's password.
File Copy, Delete
Menu path: System Manager - File - Copy/Delete
Menu path: Off-line - File - Copy/Delete
These commands allow you to carry out the MS-DOS commands `Copy' and `Delete', without quitting
the Cordless System Manager. By selecting either copy or delete, the first screen displays the default
directory (the directory of the Cordless System Manager). To change to another drive, type A...D and
then type the path name.
Add Extension
Menu path: System Manager - Administrate - Add
This command defines one or more Portables in the IC-CU_ data base. The command assigns the
following items to an Extension Number (telephone number):
- A-protocol: Portable Technical Number (PTN).
- GAP-protocol: Temporary Portable User Idetity (TPUI)
The program also takes the first free Portable Technical Number (PTN). PTNs are assigned on a cyclic
base from 1 to 4094. In the IC system the Portable Telephone is identified by its TPUI / PTN.
After completing this command the Portables must be programmed by the Subsription command.
The Extension Numbers can be entered as a range of numbers (e.g. 950 to 992) or as
single numbers (e.g.: 273, 278, 290 etc.). Defining a range of numbers is called Block Assignment.
Block Assignment
When block assignment is done, specify the first (lowest) Extension Number and then the last Extension
Number. The message `Add range of portables? Y (Yes/No)' is displayed. Confirm by pressing Y(es).